If it’s defective the machine will fill with water even when it’s not getting any power. The water inlet valve is often the main culprit here. The door seal can cause water leaks if it’s torn, and leaks can also come from the drain hose. If the drum seal is worn this can lead to water leaking into the bearings and they may fail.

If the drain pump is damaged it may leak water. Wear and tear on the drum can cause excess vibration. Suspension springs and rods can break, and balance rings can lose fluids. Shock absorbers that connect the drum to the chassis could be defective, and so could the concrete weights in older appliances. The washing machine needs to be level to avoid these issues. The drum bearing can wear and need re-sealing, and you can experience problems with the drive pulley and the motor coupling.

The drain pipe could be blocked, and the filter obstructed. Or there’s something stuck in the drum causing it to rattle during the cycle. The drain pump can get blocked, the water pump belt can break, and if the door won’t lock this can be another factor that prevents the machine from emptying water.Įxcessive noise can be produced when bearings are faulty. The machine also won’t spin if the lid switch is faulty, the drive belt is broken, or the door won’t close.Īgain, this is most likely to be caused by a kinked or blocked hose, or a blocked filter. Bosch washing machine problems with spin can be easily fixed by a qualified engineer. A blocked filter will also have the same effect as will an unbalanced load. This could be an obstruction or kink in the cold-water hose or the waste hose. You’ll need a qualified electrician to sort these issues out safely. This indicates a problem with the plug, electrical socket, or circuit breaker When your washing machine continually trips the electrics, it could be due to a wire shorting, a water leak into the electrics, or a motor or heater snag.

Bosch Washer Dryer Wet 2820 Manual